Envoy NT9010A Guida di Installazione Scaricare il pdf (Pagina 61)

Appendix D: WLS925L-433 Mini Door/

Window Contact Installation Instructions

Remove Cover

At the notched location on the cover, insert the flat

blade of a small screwdriver between the base and the

cover and twist the screwdriver to pop the cover off.

Install Battery

Use care when installing the battery and observe the

correct polarity (see diagram below). Use only

Eveready Lithium Energizer No. EL123AP battery.

NOTE:Battery

replacement must

only be done by a

qualified techni-

cian.

WARNING!:

Battery may explode if mistreated.

Do not recharge, disassemble or dis-

pose of in fire.

Locate Transmitter

Locate where the transmitter is to

be mounted. Perform the Module

Placement Test to ensure that the

selected location is in range of

the wireless receiver (see receiver

Installation Manual for instruc-

tion).

Determine where the magnet will

be placed. In order to activate the reed switch, the

magnet must line up with the end of the transmitter.

Remove Circuit Board

Before mounting the unit, remove the circuit board.

At the notched location on the base which is on the

same side as the reed switch, insert the blade of a

small screwdriver between the base wall and the bot-

tom of the circuit board and pry the circuit board up.

NOTE:Do not touch the coils on the circuit board

as this may damage the unit.

Mount Transmitter and Magnet

Mount the backplate of the transmitter using the

screws provided and replace the circuit board. The

head of the screw must be below the circuit board so

that the sensor is not shorted out. Use flat-headed

screws only.

Mount the magnet no more than ¼" (6.4mm) from

the transmitter. Use the spacers provided . Once the

unit and magnet are mounted, open and close the

window/door to ensure that none of the parts inter-

fere with this movement. Only one magnet can be

used per transmitter.

Using External Contacts

The external contact

terminals can be used

to connect external

contacts or other

switches/devices to the

universal transmitter.

Install the additional

device as per the manu-

facturer’s instruction. Connect the device to the con-

tact terminals of the WLS925L-433.

The input is normally closed and is not supervised.

For UL installations, the wires connecting the external

device to the input terminals must not exceed 36"

(90.5 cm) in length. The contact and transmitter must

also be in the same room.

For non-UL installations, the wires connecting the

external device to the input terminals can be any

length provided that the resistance of the wire does

not exceed 100Ω.

Only one contact can be used. If an external contact is

used, do not install the magnet.

Tamper Switch

There is one tamper switch on the WLS925L-433

board. Removing the cover will cause a zone tamper.

Enrolling a WLS925L-433

On the back of the door contact housing, there will be

two serial numbers, a five digit and six digit. Please

refer to your receiver installation manual for informa-

tion on which serial number should be enrolled.

1 2 ... 56 57 58 59 60 61 62 63 64

Commenti su questo manuale

Nessun commento

Envoy NT9010A Guida di Installazione Pagina 61

Commenti su questo manuale