Envoy NT9010A Guida di Installazione Scaricare il pdf (Pagina 32)

Chapter 2: Advanced Programming

• [2] - Auto-Arm Enable/Disable

Enter [2] to enable (three keypad beeps) or disable (one long beep) the auto-

arm feature.

• [3] - Auto-Arm Schedule

Enter [3] to change the auto-arm time.

Enter the auto-arm time in 24-hour format (i.e. enter a 4-digit number in

[hhmm] format).

• [4] - System Test

For step-by-step instructions on performing a system test, see the NT9010

User’s Guide (“Full System Test”). When [4] is pressed the system will perform

the following:

■ sound the alarm output for two seconds

■ light all lights on the keypad

■ sound the keypad buzzer for two seconds

■ test the NT9010 battery

■ send a System Test Reporting code, if programmed (see 2.3.12

Communicator Reporting Codes on page 44).

• [5] - Enable DLS (Downloading)

When [5] is pressed the system will turn on the downloading option for 1 or 6

hours. During this time the system will answer incoming downloading calls (see

2.3.14 Downloading* on page 47).

• [6] – User-Initiated Call-Up

When [6] is pressed, the system will initiate a call to the downloading computer.

• [7] Telephone Volume Control

You can change the volume of the voice prompts heard when you access the

NT9010 system by telephone. When you press [7], the NT9010 will prompt

“Phone Volume is High. To change phone volume, press ‘1’. To exit press #.”

Options are ‘Low’, ‘Medium’, and ‘High’, with ‘High’ as the default. You can

change the current selection by pressing [1].

NOTE: To change the volume of the voice prompts from the NT9010 unit

you must use the Volume Key on the NT9010.

[*] [8] Flash Programming / Advanced Programming

Enter [✱][8] followed by the Installer Code to enter Flash Programming, or the

Advanced Programming sections (see Section 2.1: Programming the NT9010 on

page 15).

[*] [9] Arming Without Entry Delay

When a system is armed with the [✱][9] command the system will remove the entry

delay from the system. After the exit delay, Delay 1 and Delay 2 type zones will be

instant and Stay/Away zones will remain bypassed. (see 2.3.1 Zone Definitions on

page 34). When the system is armed in this mode, the Armed light will be flashing

and NT9010 will announce that there are zones bypassed.

For more information regarding this feature, see the NT9010 User’s Guide.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 63 64

Nessun commento

Envoy NT9010A Guida di Installazione Pagina 32