Envoy NT9010A Guida di Installazione Scaricare il pdf (Pagina 47)

Section 2.3: Changing Other NT9010 Functions

If the SIA Sends Automatic Reporting Codes option is enabled the system will

operate as follows:

1. If the reporting code for an event is programmed as [00] the system will not

attempt to call the central station.

2. If the reporting code for an event is programmed as anything from [01] to [FF]

the system will AUTOMATICALLY generate the zone or access code number.

3. Bypassed zones will always be identified when partial closing of the system occurs.

The Communicator Call Direction Options can be used to disable reporting of

events such as Openings/Closings. Also, if all the Opening/Closing reporting codes

were programmed as [00] the system would not report.

If the SIA Sends Automatic Reporting Codes option is disabled the system will

operate as follows:

1. If the reporting code for an event is programmed as [00] or [FF] the system will

not attempt to call central station.

2. If the reporting code for an event is programmed as anything from [01] to [FE]

the system will send the programmed reporting code.

3. Bypassed zones will not be identified when partial closing of the system occurs.

NOTE: The zone number for Zone Low Battery and Zone Fault events will

not be identified when Programmed SIA is used.

Communicator Format. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Section [360]

SIA Sends Automatic Reporting Codes. . . . . . . . . . . . . . . Section [381], Option [3]

Communicator Call Direction Options . . . . . . . . . . . . . . . . .Sections [361] to [368]

SIA Identifiers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Appendix B

Pager Format

The Communicator Format option for either telephone number can be pro-

grammed for Pager Format. If an event occurs and the Communicator Call Direc-

tion options direct the call to a telephone number with the Pager Format selected

the system will attempt to page.

When calling a pager extra digits will be required to make it work properly.

The following is a list of Hex digits and what function they perform:

HEX (B) - simulates the [✱] key on a Touch Tone telephone

HEX (C) - simulates the [#] key on a Touch Tone telephone, or

end of telephone number marker

HEX (D) - forces the system to search for dial tone

HEX (E) - forces the system to pause for 2 seconds

HEX (F) - end of telephone number marker

The system will attempt to call the pager one time. After dialing the digits in the

telephone number the system will send the account number and reporting code

followed by the [#] key (Hex [C]).

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 63 64

Nessun commento

Envoy NT9010A Guida di Installazione Pagina 47