Envoy NT9010A Guida di Installazione Scaricare il pdf (Pagina 19)

Chapter 2: Advanced Programming

Section 2.1: Programming the NT9010

The chapter describes how to use advanced programming. For instructions on using Flash Programming, please

see Chapter 1: Quick Set Up Guide.

2.1.1 How to Enter

Advanced

Programming

You can use the Advanced Programming to set all communicator and system

options. The Installer Code is [5555] at default, but should be changed to prevent

unauthorized access to programming.

Step 1: From any keypad enter [✱][8][Installer Code].

• The System light will flash and the Armed light will turn on to indicate you are

in programming

• The NT9010 will announce “To use Flash Programming press 1. To bypass Flash

Programming press 2.”

Step 2: To skip Flash Programming and go to the advanced programming sections,

press [2].

Step 3: Enter the 3-digit section number you want to program.

• The Armed light will turn off and the Ready light will turn on to indicate the sys-

tem is ready for the information for the selected section

• You can use the Forward (Playback) button to go forward through the advanced

programming data. The Backward (Record) button will not work in the

advanced programming sections, except for sections [301] to [303], and [402].

Step 4: Sections [802], [804], or [807] have 2- or 3-digit sub-sections. To access

programming in these sections enter the programming sub-section number.

NOTE: If the section number entered is not valid, the NT9010 will sound an

error tone and say the section number that was entered.

Installer Code . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Section [006]

2.1.2 Programming

Decimal Data

When the Ready light is ON the NT9010 is waiting for the information to be pro-

grammed for the selected section.

If a digit is entered for each program box in a section the system will automatically exit

from the section. It will turn OFF the Ready light and turn the Armed light back ON.

You can also press the [#] key to exit a section before entering data for every box.

This is handy if you only need to change the first few program boxes. All other loca-

tions in the section will remain unchanged. If the [#] key is pressed the system will

turn OFF the Ready light, turn ON the Armed light and exit from the section.

You can use also the Forward (Playback) button to go forwards through the pro-

gramming data. The Backward (Record) button will not work in the advanced pro-

gramming sections (except for sections [301] to [303], and section [402]).

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 63 64

Nessun commento

Envoy NT9010A Guida di Installazione Pagina 19