Envoy NT9010A Guida di Installazione Scaricare il pdf (Pagina 46)

Chapter 2: Advanced Programming

If Contact ID Sends Automatic Reporting Codes is selected, the system will

automatically generate a reporting code for each event. These identifiers are listed

in Appendix A. If the Automatic Contact ID option is not selected, reporting codes

must be programmed. The 2-digit entry determines the type of alarm. The system

will automatically generate all other information, including the zone number.

NOTE:If the Automatic Contact ID option is selected, the system will auto-

matically generate all zone and access code numbers, eliminating the need

to program these items.

NOTE:Regardless of the zone type programmed, the system will report all

zones as burglary zones when Automatic Contact ID is selected. If you need to

report other zone types, you must use Programmed Contact ID reporting codes.

NOTE: The zone number for Zone Low Battery and Zone Fault events will

not be identified when Programmed Contact ID is used.

If the Contact ID uses Automatic Reporting Codes option is enabled, the sys-

tem will operate as follows:

1. If an event’s reporting code is programmed as [00], the system will not attempt

to call the central station.

2. If the reporting code for an event is programmed as anything from [01] to [FF],

the system will automatically generate the zone or access code number. See

Appendix A for a list of the codes which will be transmitted.

If the Contact ID uses Programmed Reporting Codes option is enabled, the

system will operate as follows:

1. If an event’s reporting code is programmed as [00] or [FF], the system will not

attempt to call central station.

2. If the reporting code for an event is programmed as anything from [01] to [FE],

the system will send the programmed reporting code.

Additional Notes on Contact ID

1. Account numbers must be four digits.

2. If the digit ‘0’ is in the account number substitute the HEX digit ‘A’ for the ‘0’.

3. All reporting codes must be two digits.

4. If the digit ‘0’ is in the reporting code substitute the HEX digit ‘A’ for the ‘0’.

5. To prevent the system from reporting an event program the reporting code for

the event as [00] or [FF].

Communicator Format Options . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Section [360]

Contact ID Sends Automatic Reporting Codes . . . . . . . . . Section [381], Option [7]

SIA (Level 2)

SIA is a specialized format that will communicate information quickly using fre-

quency shift keying (FSK) rather than pulses. The SIA format will automatically gen-

erate the type of signal being transmitted, such as Burglary, Fire, Panic etc. The two

digit reporting code is used to identify the zone or access code number.

If the SIA format is selected the system can be programmed to automatically gener-

ate all zone and access code numbers eliminating the need to program these items.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 63 64

Nessun commento

Envoy NT9010A Guida di Installazione Pagina 46