Envoy NT9010A Guida di Installazione Scaricare il pdf (Pagina 43)

Section 2.3: Changing Other NT9010 Functions

RF Jamming Detection Zone. . . . . . . . . . . . . . . . . . . . . . . . . . . Section [807]-[093]

2.3.7 Zone Tamper/

Fault Options

By enabling Tampers/Faults Do Not Show as Open, faults and tampers for wire-

less zones will not be annunciated, and will be hidden from the end user. If the

option is disabled, faults and tampers will be annunciated.

NOTE:Once a zone is tampered or faulted, it must be completely restored

before the trouble condition will clear.

✱Tampers/Faults Do Not Show As Open. . . . . . . . . . . . . . Section [013], Option [4]

2.3.8

Communicator

Dialing

If the Communicator Disable option is selected the system will never attempt to

call central station. If the Communicator is enabled, the system will attempt to call

central station when an event occurs that has a valid reporting code programmed

(see 2.3.12 Communicator Reporting Codes on page 44). You must also pro-

gram a valid telephone number for the communicator to work.

Communicator Call Direction Options are used to select where the system will

send different kinds of reporting codes when events occur. You can choose to have

the system send reporting codes to:

• 1st telephone number

• 2nd telephone number

These options are programmed separately for each type of reporting code. The dif-

ferent types of reporting codes are:

• Alarm/Restore codes

• Tamper Alarm/Restore codes

• Opening/Closing codes

• System Maintenance Alarm/Restore codes

• System Test Transmission codes

If DTMF Dialing is enabled the system will dial using DTMF (Touch-Tone). If Switch

to Pulse Dial is enabled the system will switch to pulse dialing on the 5th attempt

to call the central station. If disabled the system will always dial DTMF.

If DTMF Dialing is disabled the system will always pulse dial.

The Post Dial Wait for Handshake determines the amount of time the system

will wait for a valid handshake from the receiver. If the system does not hear the

handshake it will consider the call a failed attempt, hang up and try again.

The Maximum Dialing Attempts determines the maximum number of attempts

the system will make to send a signal to the central station before indicating a Fail-

ure to Communicate (FTC) trouble condition. The 3rd telephone Number can be

used to back up the 1st in this situation (see 2.3.9 Communicator Telephone

Numbers on page 40).

NOTE: Contact your local telephone company to confirm which settings

should be used.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 63 64

Commenti su questo manuale

Nessun commento

Envoy NT9010A Guida di Installazione Pagina 43

Commenti su questo manuale