Envoy NT9010A Guida di Installazione Scaricare il pdf (Pagina 20)

Chapter 2: Advanced Programming

2.1.3 Programming

Hexadecimal

Data

You may need to enter hexadecimal (HEX) digits for some of the programming sec-

tions. To program a HEX digit press the function button corresponding to the HEX

digit you want to program:

Button Name HEX Digit

Stay A

Away B

Chime C

Exit D

Status E

Volume F

If you enter information into a section and make a mistake, press the [#] key to exit

the section. Select that section again and re-enter the information correctly.

If you are using a pulse communications format, a decimal zero [0] does not trans-

mit. Programming a zero [0] tells the system not to send any pulses for that digit. To

make a zero [0] transmit, it must be programmed as a Hexadecimal ‘A’.

2.1.4 Programming

Tog gle

Options

Some sections contain several toggle options. Refer to the Programming Work-

sheets to determine what each option represents. When you enter a toggle option

section, the NT9010 recites the numbers of the options that are currently ON.

Press the number corresponding to the option to toggle it ON or OFF. Once all the

toggle options have been selected correctly press the [#] key to exit the section and

save the changes.

2.1.5 Programming

Audio Labels

You can program audio labels for the system, and for each of the zones. If you

enroll the zones using Flash Programming, you can choose from five pre-set labels

for the zone (please see Chapter 1: Quick Set Up).

Alternatively, you can program custom labels using the advanced programming

sections. To program or change a label:

1. From Advanced Programming, enter section [807].

2. Enter the 3-digit sub-section number of the label ([601] to [633]). The system

announces the section number and then recites the words presently programmed

in the label. Each label may have up to six words. The system then prompts:

“Enter three digit word. To exit, press pound”.

3. Enter the 3-digit code for each word you want to program. You can enter up to

six words for each label. Please see Appendix A: Audio Label Library on page

27 in Programming Worksheets for a list of the 3-digit codes for each available

word. To add numbers to a label, see Adding Numbers to Labels on page 17.

If your label is less than six words, press [#] at the end of the label.

4. If you want to use a recorded label, in place of the first word of the label enter

[244], then the number of the label [001] to [005]. The recorded label will

replace all six words in the section. To record a label, see Recording Custom

Labels on page 17.

5. When you have entered the label, the system will recite it. If the label is correct,

press [#]. To change the label, repeat steps 1-4, above.

6. Record the new label in the appropriate section of the Programming Work-

sheets.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 63 64

Commenti su questo manuale

Nessun commento

Envoy NT9010A Guida di Installazione Pagina 20

Commenti su questo manuale