Envoy NT9010A Guida di Installazione Scaricare il pdf (Pagina 24)

Chapter 2: Advanced Programming

Supervisor Codes - Access Codes [41] to [42]

Supervisor Codes can program additional access codes. By default, Supervisor codes

have the same attribute programming as the Master code. You can change the

attribute programming for these codes by following the instructions in this section.

Maintenance Code

The maintenance code can only be used to arm and disarm the system. The main-

tenance code will also allow remote (telephone) access to the system.

It cannot be used to bypass zones, or for any other function. This code can only be

programmed in Advanced Programming.

Installer’s Code

You will use the Installer’s Code to set up and to program the system. The Installer

Code is [5555] at default, but should be changed to prevent unauthorized access

to programming.

Telephone Access Code

If the NT9010 system is connected to the premise telephone line, users will be able

to access their system using a premise or phone (see 2.2.1 Accessing the NT9010

System Using a Telephone on page 18). Users will need to enter a Telephone

Access Code before they can use the NT9010 system. The default Telephone Access

Code is [✱✱✱]. You can change this to any 3 digit code using numbers 0 through 9

as well as the [✱] and [#] keys. This access code can only be changed through

Advanced Programming.

NOTE: Avoid programming this code as a valid 3 digit area code or tele-

phone service. Avoid numbers such as [911], [411], [611] or [0XX]. Do not try

to exit this section by pressing [#], it will be accepted as a valid digit. To exit,

program all 3 digits of the code or press [Forward].

Programming Access Code Attributes

Attributes determine what abilities an access code will have.

By default, each code has the attributes of the code used to program it. For exam-

ple, if you use the Master code to program other access codes, the new codes will

have the same attributes as the Master code. You can change the attribute pro-

gramming by following the instructions below.

You cannot change Master code attribute programming. The Master code has all

attributes turned on, except for the Bell Squawk on Arming/Disarming attribute.

To program each attribute:

1. Enter [✱][5][Master code][9] to enter the attribute programming mode.

2. Enter the 2-digit number of the access code you want to edit.

3. Enter the attribute number to toggle it on or off.

The programmable attributes are as follows:

• Attribute 1: User enabled for arming, disarming, alarm reset, auto-arm cancel

(on by default)

• Attribute 2: For future use

• Attribute 3: Zone Bypass enabled

This attribute allows the user to bypass zones.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 63 64

Commenti su questo manuale

Nessun commento

Envoy NT9010A Guida di Installazione Pagina 24

Commenti su questo manuale