Envoy NT9010A Guida Utente Scaricare il pdf (Pagina 9)

Introduction

Fire Detection This NT9010 controller is capable of monitoring fire detection devices such as

smoke detectors and providing a warning if a fire condition is detected. Good fire

detection depends on having an adequate number of detectors placed in appro-

priate locations. The system must be installed in accordance with NFPA 72

(N.F.P.A., Batterymarch Park, Quincey MA 02269). Carefully review Fire Safety on

page 23.

NOTE: Your installer must enable the fire detection portion of this equip-

ment for it to work.

Te sti ng To make sure your system continues to work as intended, you must test your sys-

tem weekly. Please refer to Testing Your System on page 20. If your system does

not work correctly, call your installer for service.

Remote

Monitoring

This system can send alarms, troubles and emergency messages over telephone

lines to a central station. If you accidentally initiate an alarm, immediately call the

central station to prevent an unnecessary response.

NOTE: Your installer must enable remote monitoring for it to work.

Maintenance With normal use, the system requires minimum maintenance, but please note the

following points:

1. Do not wash the security equipment with a wet cloth. Light dusting with a

slightly moistened cloth should remove normal dust accumulations.

2. Use the system test described in Testing Your System on page 20 to check

the battery condition of the NT9010 controller. We recommend that the stand-

by battery be replaced every three years.

3. Consult the manufacturer’s literature for testing and maintenance instructions

for other system devices such as smoke detectors, motion detectors, and glass-

break detectors. For instructions on replacing detector batteries, see Replacing

Batteries on page 26.

NOTE: The NT9010 is only compatible with DSC wireless devices.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 39 40

Nessun commento

Envoy NT9010A Guida Utente Pagina 9